Heavy 10mm Pistol & Handgun Ammunition

SKU: 21C/20
Price:
$31.55

Qty: - +
   - OR -   

Item 21C

Heavy 10mm Ammo -  220 gr. Hard Cast - FN (1200 fps/ME 703 ft. lbs.) - 20 Round Box

Item 21C (a 220gr. Hard Cast plain based LFN) is the absolute heaviest bullet that can be fired through 10mm pistols. With it’s flat nose it will penetrate staright and very deeply into muscle and bone. Straight line penetration into living tissue will exceed three feet.
Please note below, my personal velocities taken from real pistols.
1.       1140 fps - Glock model 20 4.6 inch barrel
2.       1175 fps - Colt Delta Elite 5 inch barrel
3.       1201 fps - Para Ordinance 1911 with Nowlin 5 inch barrel     

Item 21C is designed for all 10mm pistols that are in ordinary working condition.

Item 21C - Exterior Ballistics Charts for several Muzzle Velocities

_______________________________

Muzzle Velocity @ 1500 fps for Item 21C

 

Muzzle Velocity @ 1400 fps for Item 21C

 

Muzzle Velocity @ 1300 fps for Item 21C

 

Muzzle Velocity @ 1200 fps for Item 21C

 

Muzzle Velocity @ 1100 fps for Item 21C

 

Muzzle Velocity @ 1000 fps for Item 21C

 

Field Proven pistol and handgun ammo. Maximum firepower ammo. Best ammunition for pistols and handguns for sale. Buffalo Bore. Strictly big bore. Strictly Business.

Attention!
You must be 18 or older to order ammunition. Ammunition must ship UPS ground. Due to Department of Transportation regulations, we cannot accept returns on Ammunition. Make sure to use the correct ammunition in your gun. Check local laws before ordering.

WyoGunner on 09/15/2013 11:34am
Will not fit in a Lone Wolf Barrel. The case has too much bulge from the heavy slug. I am still a Buffalo Bore fan. I use it in my .460 Rowland. Would fit in a stock barrel.
rambouillet on 08/21/2013 10:19pm
Glock 20SF. Factory length barrel. Took down a 350lb rambouillet at 30 yards on the run. 1 shot and it was down with a clean entry and exit hole. Went through wool, rib, lung, spine, lung and again through wool. He took 1 step and was down. Another shot in the brain to finish the job. Looked for the bullet but couldnt find it. Buffalo bore 220gr hard cast is dead accurate and stabilized in factory barrel. I tried another popular brands 230gr hard cast 10mm and it didnt stabilize and was inaccurate in the factory barrel. The other brands 230gr accuracy was fine in my LW 4.5" but didn't reliably feed. Buffalo bore makes a great round, but little pricey for only a 20 round box.
Scott M on 06/01/2013 09:16pm
I needed a 3/8 hole in a piece of 1/4 inch sheet steel. Location specific but did not have to be perfect. I was jury-rigging a foundation plate for mounting a block and tackle on my mother-in-laws pole barn. Drill bit broke with the last hole. I let it get to hot for too long. Anyways, time to improvise. I had these in my CC Glock 29. My mother-in-law, the wife, and a couple other people thought I was nuts. Probably am. I took the shots from about ten feet away from behind some cover and wearing a welder's mask. It suffices to say they did the job. Two neat little holes. No long pain in the a** trip to find a steel bit that late on a Sunday.
Locke Mellott on 11/07/2012 09:03am
I used this load on a whitetail doe who was below me a few feet and slightly quartering away at 15 yards. The 220 Hardcast bullet entered the undisturbed and feeding animal's shoulder crease and made a .40 caliber entrance hole I could not quite get my finger through. It left a thumb sized hole in the ribcage, and broke an inch chunk out of one rib. It clipped the top of the heart and the hole in the soft tissue looked to be about the diameter of a Sharpie marker. The bullet exited low between the far shoulder and neck, and I could not quite get my finger through the .40 caliber exit hole. At the shot she pulled her head up and took about five jumps before looking back to see what the fuss was all about. She stood there for about three seconds, and was down for the count. I would estimate the total time from shot to complete stillness to be seven seconds. The penetration was perfectly straight line and I could not have been happier. I am not a handgun hunter per se, and have only shot one other whitetail with 180 grain Hydra-Shocks. Those hollow point bullets were such a disappointing eye opener, and I began to search for a different projectile for use on big game.

I am very pleased with both Tim and his company, and he has taken the time to email me back on my lengthy and specific questions, which is very appreciated and noticeably different than most ammunition manufacturers out there.

I give Buffalo Bore Ammunition a top shelf rating!
Joshua Needham on 10/09/2012 08:09pm
I trust nothing other than Buffalo Bore 220 Grain 10MM bullets when I step into the dark woods. There is no other manufacturer that produces a quality round like this one that will protect you from the largest North American meat eaters! GREAT Ammo!
Arch on 06/26/2010 07:44am
The bullets used in this load have a small shoulder just ahead of the case mouth. When fully chambered In my S
T Outlaw on 03/13/2010 09:39pm
1197fps average out of a G29 with a KKM 4 3/4" barrel.

Add Your Review


Your Name:
Email Address:
Review:
Note: HTML is not translated! Your email address will not be shared with anyone.
Your Rating: 5
Verification: The Captcha image
Reload Image  |  Phonetic Spelling

Your Name:
Your Email:
Friends Name:
Friends Email:
Subject:
Message:
Verification: The Captcha image
Reload Image  |  Phonetic Spelling